Infinite Peripherals SCOM-100 User Manual Page 12

  • Download
  • Add to my manuals
  • Print
  • Page
    / 75
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 11
SCOM-100, User guide 12
The circuit displayed on the center uses an external
shunt resistor (~51.3 ) wired parallel to the input in
order to measure current signals (e.g. 0-20/4-20mA).
The circuit displayed on the right side of the page uses
an external resistor (Rx) to measure DC voltage (Vx). Rx
and Rin (2K) form a voltage divider. The following table
illustrates the applicable resistor Rx values for different
DC voltages:
Vx Rx Vin
0..1V 0 0 -1V
0..5V 8K, 1/4W 0 -1V
0..30V 58K, 1/4W 0 -1V
0..60V 118K, 1/4W 0 -1V
0..100V 198K, 1/4W 0 -1V
Note: In case of low voltage measurements, use short
and shielded wiring to avoid 50Hz (60Hz) line noise
inteference.
Page view 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 74 75

Comments to this Manuals

No comments